Open The Electrical Compartment - Rational iCombi Pro Original Installation Manual

6 | Electrical connection
The condensation hood is connected to the power supply with a perman-
n
ent connection. The permanent connection with an all-pole disconnection
device with at least a 3 mm [1/8 inch] contact gap must be accessible on
site.
If the condensation hood is connected with a power cable, the power cord
n
must always be accessible.
The condensation hood must be fused with a maximum of 16 A by the
n
customer.
The condensation hood must be fused with a maximum of 15 A by the
n
customer.
The condensation hood is equipped with an approx. 2 m [approx. 6 1/2
n
inches] long connection cable without a plug.
If the connecting cable is replaced, use a H05 RN-F 3x1.5 mm
n
cable at the very least. The mains power cable may only be replaced by
qualified personnel authorised by the manufacturer.
Before you disconnect the power cord from the mains or reconnect it to
n
the mains, make sure that the unit is switched off to prevent the condensa-
tion hood from running.
Notes for units with the Uninterrupted Power Supply (UPS) option
With the UPS option, electronic components can be connected to a stable
voltage supply. With this option, a second connection cable for the electronic
components will be routed out of the unit. When performing servicing work
on the unit, both voltage sources must be disconnected from the mains.
6.2

Open the electrical compartment

The electrical compartment is behind the left side panel.
a
The unit is standing on its intended installation surface.
a
The unit is switched off.
a
All power sources are switched off by way of an external circuit breaker.
1. Open the electrical compartment as described below for the relevant unit
size.
50 / 108 80.06.070_iCombiPro-iCombiClassic_IM_en-GB
2
quality