Table of Contents
Advertisement
User's Manual
6.1 SETUP
Pressing the [SETUP] key in any interface to enter the Setup menu, press the arrow key [▲], [ ▼], [ ], [ ]
to select or switch to the parameter setting, as shown in the following figure.
6.1.1 Sync Source
The synchronization source determines the measurement interval of the input signal, which will be the
interval in the data update cycle from the initial point of the rising or falling slope through zero to the final
point of the rising or falling slope through zero, as shown in the following figure
●: rising through zero
○: falling through zero
If there is no or only one rising slope or falling slope in the data update interval, the entire data update
interval is used as the measurement interval.
Instruments.uni-trend.com
UTE310 Digital Power Meter
58 / 99
Advertisement
Table of Contents
