Table of Contents
Advertisement
User's Manual
Timeout Setup
1.
Using the [▲] or [▼] key in the SETUP menu to select "Auto Timer" (the option is fill with red
shading which means it is selected).
2. Pressing the [ ] or [ ] key to select 1s, 2s, 5s, 10s, 20s.
3. Using the [▲] or [▼] key to select other setting option or pressing the [ESC] key to go back to
the measurement interface.
6.1.7
Auto Rate Sync (Automatic data synchronization
Auto Rate Sync is a dedicated sync source when the data update interval is Auto, and this setting is only valid
when the data update interval is set to Auto.
Auto Rate Sync Setup
1.
Using the [▲] or [▼] key in the SETUP menu to select "Auto Rate Sync" (the option is fill with red
shading which means it is selected).
2. Pressing the [ ] or [ ] key to select U or I.
3. Using the [▲] or [▼] key to select other setting option or pressing the [ESC] key to go back to
the measurement interface.
6.1.8
Reset Init (Initialization)
After the instrument is initialized, the setting parameter will restore to the factory settings. The factory
setting is shown in the table below.
Measuring Range
Measurement Mode
Sync Source
Line Filter
Frequency Filter
Crest Factor
Data UpRate
Auto Timer
Auto Rate Sync
Average state
Instruments.uni-trend.com
Parameter
)
Factory Setting
Auto
RMS
U
OFF
OFF
3
0.25S
1S
U
OFF
UTE310 Digital Power Meter
64 / 99
Advertisement
Table of Contents
