Usb Interface - UNI-T UTE310 User Manual

User's Manual
The above communication method only supports Modbus TCP/IP.

In order to ensure stable communication, it is forbidden to use other interfaces for communication

when using RJ-45 interface.
The number mentioned in the above schematic indicates the pin numbers of RJ-45 interface, other

pins not listed are not used.
When a PC directly connect to a single UTE310, please use a cross-cable (one port is T586A and

the other port is T586B).
The above wiring represents the connection between the send end and the receive end of the

data, and does not fully represent the actual physical connection.

8.3 USB Interface

When use USB interface to communication, it is not necessary to set USB parameters on the instrument.
Electrical and mechanical specifications
USB Connecting Figure
Instruments.uni-trend.com
Port number
Interface type
Transmission system
Transmission rate
PC requirement
1
B type USB (plug)
USB 2.0
HS(high speed;480Mbps) and FS(full
speed;12Mbps)
User-defined
32-bit or 64-bit Windows 7 and higher systems
with USB ports
UTE310 Digital Power Meter
89 / 99