Eizo SCD 19102 Instructions For Use Manual page 37

Main menu
SCD 19102 / SMD 19102
Instructions for Use, 08/2015
Function Adjustment /
setting range
DPMS setting
DPMS On
Off
Default: On
DPMS Off mode Dimmed
(backlight)
Off
Default: Dimmed
LUT choice
LUT backlight On / Off
command
Default: On
Select gamma 1 ... 5
curve
Default:
SCD 19102: LUT
1
6.3 Description of OSD menu
Description
The DPMS (Display Power Man-
agement System) can be
switched on/off
When the DPMS is activated and
there is no input signal, the back-
light is switched off or dimmed (de-
pending on the parameter for the
"DPMS Off Mode": see below).
This saves energy and increases
the lifespan of the backlight.
"DPMS Off mode" can be set to
"Dimmed" or "Off". The backlight is
then either dimmed or switched off
when the DPMS mode is active.
Permits access to the backlight
• When "On" is set, the backlight
cannot be changed in the
"Brightness/contrast" menu.
• When "Off" is set, the backlight
can be changed in the "Bright-
ness/contrast" menu.
Gamma curve selection:
information on the selected curve
The LUTs that can be selected are
displayed in the table in the OSD
menu.
See Monitor adjustment – LUT
[} 53]
Start­up
37