Eizo SCD 19102 Instructions For Use Manual page 63

Optimize geometry/resolution
The active resolution range is defined by the values of the "Horizontal resolution" and "Verti-
cal resolution" input fields. This range is displayed in the center of the monitor in black.
The inactive resolution range is the unused range between the active resolution and the
maximum resolution of the monitor, namely, 1280 x 1024. In Force Mode, this range is dis-
played gray (gray scale monitors) or blue (color monitors).
To adapt the active resolution range to the actual video signal resolution, perform the follow-
ing steps:
1. Open a test pattern with a clearly defined border (e.g. SMPTE image).
2. Open the "Live mode" menu: Main menu → Servicelevel 2 → Force Mode → Live mode.
3. Select either "For static pictures" or "For motion pictures" in line 6 in the "Live mode"
menu and confirm using key 2.
4. Use the "Horizontal blank pixels" input field to shift the left edge of the SMPTE image
pixel-exact to the left internal border of the gray/blue area.
5. Correct the values in the "Horizontal resolution" input field until the right internal border
of the gray/blue area is pixel-exact at the right edge of the SMPTE image.
6. Use the "Vertical blank pixels" input field to shift the top edge of the SMPTE image pixel-
exact to the top internal border of the gray/blue area.
7. Correct the values in the "Vertical resolution" input field until the bottom internal border
of the gray/blue area is pixel-exact at the bottom edge of the SMPTE image.
8. Execute the "Force"
Note: Gray/blue range not visible
If no gray/blue area is visible on the left and right sides of the image, reduce the "hori-
zontal resolution" until the gray/blue area becomes visible. If no gray/blue area is visible
on the top and bottom sides of the image, reduce the "Vertical resolution" until the gray/
blue area becomes visible.
SCD 19102 / SMD 19102
Instructions for Use, 08/2015
command with key 2.
Start­up
6.4 System settings
63