Setup and installation
4.2 Installing the monitor
Change of environment
If the device is brought into a warm environment from a cold one, condensation may form in
the device. The device should not be switched on until all the condensed water has evapo-
rated, including that inside the device. This may take several hours, depending on the condi-
tions.
4.2 Installing the monitor
Ceiling suspension
Multiple monitors can be installed flush horizontally and vertically to one another.
Comply with the following during installation (100 mm hole spacing according to VESA stan-
dard):
Information on the fastening screws
Number
Thread
Strength
Insertion depth
Torque
Fig.:
Insertion depth of mounting screws
See also
Installation site [} 15]
Installing the base and cable (SCD 19102) [} 22]
16
4
M4
8.8
7 mm minimum / 9 mm maximum
Max. 3 Nm
Instructions for Use, 08/2015
SCD 19102 / SMD 19102