Eizo SCD 19102 Instructions For Use Manual page 58

Start­up
6.4 System settings
Note: If the "Reset" setting is selected, all learned values are deactivated in the current
Force Mode window.
Live mode
If a timing is not detected by the monitor or if the image is not satisfactory, a fine adjustment
can be performed using "Live mode" or "Position/Zoom" and "Frequency/Phase".
"Live mode" is used for step-by-step approximation of an unknown timing. The changes in
the test pattern are output live on the monitor.
Note
All settings in "Live mode" must be carried out with the zoom factor "1 to 1" ("Position/
Zoom" menu).
Note
Always save data with "Force"
The timing data are only entered into memory by the "Force" command, and the image is
then displayed with the new parameters.
58
SCD 19102 / SMD 19102
Instructions for Use, 08/2015