Oil Pump Removal; Oil Pump Inspection - KYMCO DINK50 Service Manual

4
. LUBRICATION SYSTEM

OIL PUMP REMOVAL

＊
Do not allow foreign matters to enter the
crankcase. Before removing the oil
pump, clean the oil pump and crankcase
surfaces.
Remove the met-in box. (  2-4)
Disconnect the oil pump control cable from
the pump body.
Disconnect the oil inlet line from the oil
pump.
Then, disconnect the oil outlet line.
＊
Before disconnecting the oil line, clip
the oil line to avoid oil flowing out and
then plug the oil line after it is
disconnected.
Remove the oil pump control cable plate
bolt and copper washer.
Remove the oil pump from the crankcase.

OIL PUMP INSPECTION

Remove the oil pump and inspect the
following items:
• Weakened O-ring
• Damage to crankcase mating surface
• Damage to pump body
• Control lever operation
• Oil leaks through oil seals
• Worn or damaged pump pinion
＊
Do not disassemble the oil pump which
cannot be used after disassembly.
4-3
www.PlanDeGraissage.org
Oil Outlet Line
Oil Inlet Line
Bolt
Control Cable Plate
O-ring
Control Lever
Oil Pump
Control Cable
Pinion