Oil Pump - KYMCO G-Dink 125i Manual

G-Dink 125i
2. Engine > Oil Pump

Oil Pump

SAFETY FIRST: Protective gloves and eyewear are recommended
at this point.
GENERAL INSTRUCTIONS
The maintenance of lubrication system can be performed with the
engine installed in the frame. Use care when removing and installing the
oil pump not to allow dust and foreign matters to enter the engine and oil
line.
Do not attempt to disassemble the oil pump. The oil pump must be
replaced as a set when it reaches its service limit.
After the oil pump is installed, check each part for oil leaks.
TROUBLESHOOTING
Oil level too low
1. Natural oil consumption
2. Oil leaks
3. Worn or poorly installed piston rings
4. Worn valve guide or seal
Poor lubrication pressure
1. Oil level too low
2. Clogged filter or oil passages
3. Not using the specified oil
Oil Pump Removal
Drain the engine oil. See the Engine Oil topic for more information.
Remove the generator cover, flywheel, starter idle gear and starter
driven gear. See the Generator topic.
79