KYMCO DINK50 Service Manual page 223

20
. HIGH-SPEED TIRE
REMOVAL METHODS

Use the valve core assembly
tool to take the valve core out and
bleed air from the tire.
＊
When removing the valve core, be
careful that the high tire pressure
may force out the valve core.
 If there is no special tool to
pry off the tire bead, use your feet
to do this as the figure shown.
＊
•Don't step on the wheel rim and
spoke wire.
•Before installing the tire, make
sure that the rim and axle bearing
are not damaged. Be careful during
installation.
 After the tire bead is separated
from the rim and before removing
the tire, press the tire bead at the
back of the valve into the rim
groove completely, Then push the
tire to the same side.
＊
It is easier to remove the tire when
it is pushed to the same side of
rim.
20-7
www.PlanDeGraissage.org
Rim Center