KYMCO DINK50 Service Manual page 229

20
. HIGH-SPEED TIRE
Install the rim protector and insert 2
tire irons at an interval of 30mm to
install the tire bead into the rim.
Press to hold the installed part of tire
bead by knees.
After 1/2 of tire bead is installed,
insert 2 tire irons at an interval of
30_ 40mm to finish the installation
in order.
＊
• Both tire irons should be pulled
out at the same time.
• The already installed part should
be pressed.
The pulled-out tire iron should be
inserted beside the other tire iron
which hasn't been pulled out.
After 2/3 of the tire bead is installed
into the rim, make sure if the installed
tire bead is completely inserted into
the rim groove.
＊
If the tire bead is not completely
inserted into the rim groove, it will
be more difficult to install the rest
part of the tire bead. Moreover,
the rim bead is easily damaged.
20-13
www.PlanDeGraissage.org