Oil Tank - KYMCO DINK50 Service Manual

4
. LUBRICATION SYSTEM

OIL TANK

OIL TANK REMOVAL
Remove the seat and met-in box. (  2-3)
Remove the battery.
Remove the battery cover screw and the
battery cover.
Remove the oil meter connector.
Remove the two bolts attaching the oil tank.
Disconnect the oil inlet line.
Drain the oil inside the oil tank into a clean
container.
Remove the oil tank.
The installation sequence is the reverse of
removal.
＊
• Connect the oil line properly.
• Bleed air from the oil pump after
installation.
• The oil tube clip (at the oil tank side)
must be locked from inside of the oil
tube joint.
www.PlanDeGraissage.org
Wire Connector
Oil Meter
Bolts
4-6