KYMCO DINK50 Service Manual page 66

5
. ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL
Remove the frame body cover. (  2-5)
Remove the two bolts attaching the air
cleaner case.
Loosen the band between the air cleaner and
carburetor to remove the air cleaner case.
Remove the carburetor cap.
Disconnect the oil pump control cable from
the pump body.
Disconnect the oil inlet line from the oil
pump.
＊
After the oil inlet line is disconnected,
plug the oil line opening to prevent oil
from flowing out.
Disconnect the auto bystarter, A.C.
generator and starter motor wire connectors.
Remove the spark plug cap.
www.PlanDeGraissage.org
Band
Carburetor Cap
AC Generator Wire
Oil Pump Control Cable
Connector
Spark Plug Cap
Air Cleaner Case
Bolt
Oil Inlet Line
5-2