Engine; Replace Toner; Toner Empty - Konica Minolta magicolor 2500W Service Manual

Field Service Ver. 1.0 Aug. 2006
9.4

ENGINE

9.4.1

REPLACE TONER

A. REPLACE TONER/(color)
Function • Moves a specific color toner cartridge to the appropriate position to allow it to be
replaced.
Use • To allow a toner cartridge to be replaced.
Setting 1. Select [ENGINE REPLACE TONER] and the specific color of toner to be replaced.
/procedure 2. The rack rotates to bring the specified color toner cartridge to the replacement posi-
tion. When the rack has stopped moving, the message [OPEN DOOR/REPLACE
TONER (color)] appears on the display.
3. Open the top cover and replace the toner cartridge.
4. Close the top cover. The initial screen will then reappear.
B. REPLACE TONER ALL
Function • Moves each toner cartridge to the appropriate position, one by one, to allow all of the
toner cartridges to be replaced with new ones.
Use • To allow all of the toner cartridges to be replaced.
Setting 1. Select [REPLACE TONER ALL].
/procedure 2. The rack rotates to bring the first color toner cartridge to the replacement position.
When the rack has finished moving, the message [OPEN DOOR/REPLACE TONER
C] appears on the display.
3. Open the top cover and replace the toner cartridge.
4. Close the top cover. Then, the message [OPEN DOOR/REPLACE TONER K]
appears on the display.
5. Repeating the same steps, replace all toner cartridges with new ones.
NOTE
• The toner cartridges are to be replaced in the order of C → K → Y → M.
6. Close the top cover. The initial screen will then reappear.
9.4.2

TONER EMPTY

Function • Specifies whether to stop or continue printing when a toner empty condition is
detected.
Use • To permit printing upon a toner empty condition.
Setting • The default setting is STOP.
/procedure
• When [STOP] is selected
The print cycle is stopped when the toner consumption rate becomes 0%.
The message shown on the control panel reads [TONER LIFE END.]
Only the orange LED stays lit up steadily.
• When [CONTINUE] is selected
A print cycle can be carried out even when the toner consumption rate becomes
0%.
The message shown on the control panel reads [TONER LIFE END.]
Both the green and orange LEDs blink.
The print cycle is stopped after 6K printed pages have been produced.
The message shown on the control panel reads [TONER LIFE END.]
Only the orange LED stays lit up steadily.
"STOP"
9. MENU (magicolor 2530 DL)
CONTINUE
87