Transfer Belt Unit - Konica Minolta magicolor 2500W Service Manual

Field Service Ver. 1.0 Aug. 2006
3.4.6

Transfer belt unit

[1]
[1]
[1]
NOTE
• When the transfer belt unit is replaced with a new one, it is necessary to reset the
maintenance counter.
For magicolor 2500W: See P.78
For magicolor 2530 DL: See P.128
For magicolor 2550/magicolor 2550DN: See P.130
A. Replacement procedure
1. Open the top cover.
2. Disconnect the connector [1].
Precaution for reconnecting the
connector
• Make sure that the connector is
connected in the correct direction.
A00VF2C535DA
3. Remove two shoulder screws [1] and
NOTE
• When replacing the transfer belt
unit, use care not to touch the sur-
face of the belt. A scratchy or dirty
belt could result in image problems.
4. To reinstall, reverse the order of
Precaution for replacing the transfer
belt unit
• After replacing the transfer belt
unit, from the Status Display menu,
select [Printer] → [Power On Test]
[2]
and execute image stabilization
control function.
A00VF2C506DA
3. Periodic check
then remove the transfer belt unit [2].
removal.
19