SMC Networks PFCA7 Series Operation Manual page 65

●Product individual parameters (continued)
Index
Sub Access
1
index
dec hex
Work_hour
0x2710 0 R
10000
(Operation time)
7000 0x1B58 0 W
7010 0x1B62 0 W
7100 0x1BBC 0 R
8000 0x1F40 0 R
8010 0x1F4A 0 R
8020 0x1F54 0 R
8030 0x1F5E 0 R
8060 0x1F7C 0 R
8070 0x1F86 0 R
1: R means Read and W means Write.
2: Refer to table below for symbols.
Data type
Symbol
(IO-Link standard)
U8
UIntegerT
U16
S16
IntegerT
F32 Float32T
C32
StringT
3: "Y" indicates that the parameter setting data is saved to the master, and "N" indicates that the parameter is not saved.
4: Read/write to unselectable items will be rejected depending on the product No.
Data
Initial
Parameter type
value
2
U32 -
OUT Test
U8 0
(Output check)
Toggle
U8 -
(Toggle output)
U16 -
Analogue output value
Inclination of flow rate
F32 -
PD a
Flow rate PD
F32 -
intercept b
S16 -
Flow rate peak value
S16 -
Flow rate bottom value
Accumulation PD
F32 -
inclination a
Accumulation PD
F32 -
intercept b
Data length
Bit[byte]
8[1]
16[2]
16[2]
32[4]
32[4]
Data
4
storage Setting value
3
N 0 to 876000
0: Normal output
N
1: Fixed output
0: Accumulated measurement
value
1: Flow rate measurement
value
16: OUT1 hardware
32: Accumulated flow SW
33: Limit deviation tolerance
SW
80: Analogue output
160: Control selection
N
208: Flow rate display unit
209: Flow rate reference
condition
210: Automatic accumulation
shut-off
224: Accumulation diagnosis
225: Flow rate diagnosis
226: Output PD diagnosis
254: Error
255: System error
Output voltage: 0.1 V increments
N
Current output: 1 mA increments
Refer to table "Inclination and
N
intercept to the units
specification". (Page 58)
Refer to table "Inclination and
N
intercept to the units
specification". (Page 58)
N
-200 to 4200
N
Refer to table "Inclination and
N
intercept to the units
specification". (Page 58)
Refer to table "Inclination and
N
intercept to the units
specification". (Page 58)
Description
Unsigned integer
Signed integer
Floating point number
Character string
-65-
Remarks
Returns the current operation
time [h].
Sets the bit in the PD to 1 when a
fixed output is received.
The current analogue output value
is returned.
The conversion method from the
communication value to the actual
measurement value is the same
as the method for process data.
No.PF※※-OMA1002