Setup / Metronome; Setup / Midi - Korg MPS-10 Owner's Manual

Hide thumbs Also See for MPS-10:

Table of Contents

MPS-10

- Parameter guide

Out Routing

Use this screen to set the output destination for each pad, IFX 1, 2, the loop, metronome, AUX In and

USB In.

Use the VALUE knob to select the output source, and press the ENTER button to toggle between

"Main", "Sub", "Off" and "Main" settings.

Note: When Metronome, AUX In and USB In are set to "Off", nothing is output from MAIN OUT or SUB OUT, but

signal is output from PHONES.

Setup / METRONOME

This screen lets you configure the settings for the metronome built into the MPS-10.

Level........................................................................................................000...100

Adjusts the volume of the metronome.

Beat..................... 1/2...24/2, 1/4...24/4, 1/8...24/8, 1/8t...24/8t, 1/16...24/16

Sets the metronome's beat (time signature).

Sound .......................................................................................................................

Selects the metronome sound (10 sounds are available).

For details on the parameters, refer to the "Effect type list" in the preset list (PDF).

Pan ............................................................................................. L16...Center...R16

Sets the metronome panning (left-right volume balance).

Configures the settings for transmitting and receiving MIDI signals.

Table of Contents