MPS-10
- Introduction
Control panel
Each button on the control panel has a built-in LED.
Only the buttons that are available in different situations (such as performing or editing) are lit up.
Buttons that are unlit do not operate.
1.
(Power) button
Turns the power on/off.
2. Display
Shows information about the KITs, looper, each of the parameters and so on.
3. MAIN VOL. knob
Adjusts the output volume for the MAIN OUT R, MAIN OUT L (MONO) and SUB OUT jacks.
4. PHONES knob
Adjusts the output volume for the PHONES jack.
5. KIT+ (INS), KIT- (DEL) buttons
Use these buttons to switch between KITs.
The buttons may work differently when you're editing.
6. METRONOME knob, button
Turn the knob to adjust the tempo of the built-in metronome. You can fine-tune the tempo setting in
units of decimals by holding down the SHIFT button while turning the knob.
METRONOME ON/OFF button: Press this button to toggle the metronome on or off.
Tip: This is also used to switch between pages and so on while editing.
7. VALUE knob, ENTER button
Use these controls to switch between KITs and edit the parameters.
ENTER button: Pressing the VALUE knob gives the same result as pressing the ENTER button, and is
used to confirm values, execute functions and access sub-menus.
8. MODE buttons
KIT: This button accesses KIT mode.
INST: This button accesses INST mode.
SAMPLE: This button accesses SAMPLE mode.
UTILITY: This button accesses UTILITY mode.
7