Parameter Guide; Kit Edit Menu; Kit Edit / Cc Pad - Korg MPS-10 Owner's Manual

Hide thumbs Also See for MPS-10:

Table of Contents

MPS-10

- Parameter guide

Parameter guide

The parameters you can edit using the KIT EDIT menu are shown below.

Note: Some settings may produce distortion or noise.

KIT Level............................................................................................................0...100

Sets the overall volume of the instruments for the currently selected KIT.

BPM Base Pad#............................................No Assign, 1...10, A, B, C, D, Pedal

Selects the pad that's used for detecting the base BPM of the currently selected KIT. The KIT's BPM is

set to the BPM used by the INST that's assigned to the specified pad.

Use this to set the respective functions for CC (continuous control) pads 1–4: TRANS (Transpose),

NOTE (Note Delay), MFX and FILTER.

Use the METRONOME knob on the CC PAD edit menu page to switch between the four pages.

Tip: You can also use track buttons 1–4 to turn these functions on/off.

TRANS (Transpose)

Transpose ................................................................................................... On, Off

Enables/disables the function that changes the pitch you hear when the sounds play.

You can select a transpose value that's set when you play each of the four CC pads.

PAD# .............................................................................1...10 / A, B, C, D / Pedal

You can also turn the function on/off for each pad, which sets whether to transpose the sound. The

pads for which this function is "On" are indicated in blue on the screen, which means that the pitches

for these sounds are controlled by CC PAD.

On/Off (Pad Transpose) ............................................................................ On, Off

Use this to select whether the Transpose function is used when the respective pad plays.

Table of Contents