Korg MPS-10 Owner's Manual page 83

MPS-10
- Parameter guide
1
Move the cursor to "Folder" and press the ENTER button to show the list of "LOOPER Data"
folders that are saved to the USB flash drive.
Use the VALUE knob to select the looper data that you want to import, and press the ENTER button
to confirm.
2
Move the cursor to "Execute" and press the ENTER button. A message is shown on the page,
confirming whether you want to import the selected set of looper data.
Press the ENTER button to execute. Press the EXIT button to cancel.
How to export looper data
Here's how to save the current set of looper data to a USB flash drive.
1
Turn the METRONOME knob to switch from the "Import" page to the "Export" page.
Note: Move the cursor to "Name" and press the ENTER button to show the rename page. ( p. 24, "Using the
Name dialog box (how to change the name)")
2
Move the cursor to "Execute" and press the ENTER button. A message is shown on the page,
confirming whether you want to export the selected set of looper data. Press the ENTER
button to execute. Press the EXIT button to cancel.
Note: If there is already a folder with the same name when you press "Execute", the message shown below
appears. To overwrite the existing data, press the ENTER button. To go back and rename the data, press the EXIT
button.
Note: To delete the data that's saved, delete the folder with the name you specified in "Name," located in the
"LOOPER" subfolder of the "MPS_10" folder on the USB flash drive.
83