Kit Edit / Insert Fx - Korg MPS-10 Owner's Manual

MPS-10
- Parameter guide
Mid Q ........................................................................................................... 0.5...10
Adjusts the range around which the frequency set in Mid Freq is boosted or cut.
Larger values make the range narrower with steeper frequency characteristics (in units of 0.1).
High Freq ......................................................................................60Hz...15.4kHz
Sets the frequency band for which the high end EQ is adjusted.
High Gain .......................................................................................-18dB ... +18dB
Adjusts the high end EQ frequency band upwards or downwards (in 0.5 dB units).

KIT EDIT / Insert FX

This section is for adjusting the Insert FX (hereafter "IFX") parameters for the currently selected KIT.
There are two IFX, and you can select the pads to which the IFX is applied from "PAD EDIT".
Use the METRONOME knob to switch between setting pages.
FX On/Off ................................................................................................... On, Off
Enables/disables the IFX effect.
Input Trim................................................................................................ 0...100%
Adjusts the input level going into the IFX. The sound may distort when using certain IFX settings.
If this happens, use this parameter to adjust the level so as to avoid distortion.
Output Level ........................................................................................... 0...100%
Adjusts the output level of the IFX. As the output volume may change depending on the IFX settings,
use this parameter to adjust the volume as appropriate.
FX Type....................................................................................................................
Selects an insert effect. (Refer to the "Effect type list" in the preset list (PDF))
Param1,2,3 ..................................................................................................0...100
The contents of Param 1, 2 and 3 differ depending on the FX Type. When you change the FX Type,
these parameters are reset to their default values.
For details on the parameters, refer to the "Effect type list" in the preset list (PDF).
51