Operating Modes And Software Setup; Nanokontrol Studio Modes; Setup For Using The Nanokontrol Studio In The Daw Mixer Control Mode; Digital Performer - Korg nanoKONTROL Studio Owner's Manual

nanoKONTROL Studio Modes

The nanoKONTROL Studio can operate in the following modes. Se-
lect the mode according to your application.
DAW Mixer Control Mode
In this mode, the controllers of the nanoKONTROL Studio will be
automatically set up for mixer control by the DAW software. You can
control the level of each channel or operate transport controls such
as mute/solo and play/stop.
Assignable Mode
In this mode, MIDI control change messages are assigned to the
controllers of the nanoKONTROL Studio. By sending MIDI control
change messages that correspond with the parameters that you
wish to control, you can easily use the nanoKONTROL Studio to
control your software synthesizer or DAW software, for example.

Operating Modes and Software Setup

Setup for using the nanoKONTROL Studio
in the DAW Mixer Control Mode
The following are examples of the setup procedures for various
DAW software titles. For details on specifying settings and using the
DAW software, refer to the instruction manual for the software.
Cubase
1. While holding down the Scene and Marker Set buttons, turn
on the nanoKONTROL Studio to set it to Cubase mode.
Once the nanoKONTROL Studio has been set to Cubase
mode, it will continue operating in that mode.
2.
In Cubase, open "Device Setup", and then add "Mackie Con-
trol" to "Devices".
3. Open the page for the added Mackie Control, and then se-
lect the nanoKONTROL Studio ports as the MIDI input and
output ports to be used.
4.
Open the "MIDI Port Setup" page, and then clear the "In
"All MIDI Inputs"" check box for nanoKONTROL Studio.

Digital Performer

1.
While holding down the Scene and Marker  buttons, turn
on the nanoKONTROL Studio to set it to Digital Performer
mode. Once the nanoKONTROL Studio has been set to Digi-
7