Kit Edit / Foot Sw - Korg MPS-10 Owner's Manual

MPS-10
- Parameter guide
CC PAD Assign ............................................................................................. (1...9)
You can set one of the nine patterns below, which are used for changing the parameter contents
according to where you strike the pads.
The corners of the triangles represent the minimum offset, and the sides of the triangles represent
the maximum offset.
Tip: On the pads indicated in gray, the offset value is reset when you strike the location in question, which lets you
revert the parameter settings to those saved in the KIT.
Tip: The setting for which the triangle is split in two is a symmetrical setting, which prevents the value from drift-
ing when you're playing rolls with two sticks.
Transition ....................................................................................................0...100
Sets the speed at which the parameter value changes when you strike a CC pad.

KIT EDIT / Foot SW

You can set which functions are used when an external switch is connected.
Foot SW1,2..................................Global, KIT+, KIT-, IFX1 On/Off, IFX2 On/Off,
LooperPlay Start/Stop, LooperRec Start/Stop, Tap Tempo, SOUND OFF, PAD
Exchange
Sets which function to assign to the connected switch.
Note: There are also foot switch settings in UTILITY. When set to "Global", the settings in UTILITY are applied.
( p.74)
When you select "PAD Exchange", the three parameters (PAD 1, PAD 2 and Polarity) shown below are
enabled.
48