Kit Edit / Main Fx - Korg MPS-10 Owner's Manual

Hide thumbs Also See for MPS-10:

Table of Contents

MPS-10

- Parameter guide

KIT EDIT / Main FX

This section is for adjusting the Main FX parameters for the currently selected KIT.

There are three types of Main FX: "MFX", "REVERB" and "FILTER". Use the METRONOME knob to

switch between setting pages.

MFX

FX On/Off ................................................................................................... On, Off

Enables/disables the MFX.

Input Trim................................................................................................ 0...100%

Adjusts the input level going into the MFX. The sound may distort when using certain MFX settings.

If this happens, use this parameter to adjust the level so as to avoid distortion.

Output Level ........................................................................................... 0...100%

Adjusts the output level of the MFX. As the output volume may change depending on the MFX set-

tings, use this parameter to adjust the volume as appropriate.

FX Type....................................................................................................................

Selects a main effect. (Refer to the "Effect type list" in the preset list (PDF))

Param1,2,3 ..................................................................................................0...100

The contents of Param 1, 2 and 3 differ depending on the MFX Type. When you change the Type, these

parameters are reset to their default values.

For details on the parameters, refer to the "Effect type list" in the preset list (PDF).

Tip: Press the EDIT button to move to the CC PAD/MFX page. ( p. 46, "MFX")

REVERB

Reverb On/Off ............................................................................................ On, Off

Enables/disables the reverb.

Input Trim................................................................................................ 0...100%

Adjusts the input level going into the Reverb. The sound may distort when using certain Reverb set-

tings.

If this happens, use this parameter to adjust the level so as to avoid distortion.

Table of Contents