Global Mode; Global P1; 1-1: Global Setup - Korg Trinity Parameter Manual

6. Global mode

In Global mode you can make settings that affect the entire instrument, such as master tuning,
MIDI settings, and memory protect. You can also assign drum samples to the drumkits.
The settings made in Global mode are backed up when the power is off, and there is no need to
write these settings into memory.

Global P1

1–1: Global Setup
1–1a
1–1b
1–1c
1–1d
1–1e
1–1f
1–1g
1–1a: Master Tune/Key Transpose
Master Tune
Adjusts the basic tuning of the entire TRINITY in steps of a single cent (a semitone = 100 cents).
With a setting of 0, A4 (middle A) will be 440 Hz.
The tuning of the TRINITY can also be tuned using MIDI RPN Fine Tune messages. (However the
TRINITY will not transmit this message.) In Sequencer mode, this message will be received on the
MIDI channel of each track, to control the Detune parameter of that track. In other modes, this
message is received only on the Global MIDI channel, and will control Master Tune.
Key Transpose
Adjusts the pitch in semitone steps, over a range of
±1 octave.
This setting is applied at the location (Post KBD or
Pre TG) specified by the "1–1b: Position" setting.
If the setting of "1–1b: Position" is Post KBD, the
range of note numbers transmitted by the TRINITY
will be affected by this setting. This setting adjusts
the overall pitch in semitone steps.
1–1b: Position
This determines the location at which Transpose (
page 132 in this manual), and Aftertouch Curve (
applied.
This setting will affect the way that MIDI data is transmitted and received, and how sequencer
recording data is handled. However it has no effect on how the internal tone generator is played
by the built-in keyboard.
1–1: Global Setup
Page Menu
Note numbers transmitted
Transpose
–12
TRINITY
24...84 36...96
TRINITY V3
(C1...C6) (C2...C7)
TRINITY plus
16...91 28...103
TRINITY V3 pro
(E0...G6) (E1...G7)
TRINITY pro
9...96 21...108
TRINITY V3 proX
(A–1...C7) (A0...C8)
TRINITY proX
[Post KBD/Pre TG]
page 129 in this manual), Velocity Curve (
page 133 in this manual) settings will be
1–1A
1–1B
1–1C
[–50...+50]
[–12...+12]
0 +12
48...108
(C3...C8)
40...115
(E2...G8)
33...120
(A1...C9)
129