Table of Contents
Advertisement
MPS-10
- Parameter guide
Decay Time..................................................................................................0...100
Sets the Decay Time for the selected block.
Decay Curve................................. Linear, Exp1, Exp2, Exp3, Log1, Log2, Log3
Sets the Decay Curve for the selected block.
Linear
Exp1
Exp2
Exp3
Copy/Paste function
If you want to copy parameters from one block to a different block, you can make these settings using
the Block Copy/Paste function. (Note that this is only for use within the same INST.)
When you select the copy source on the Block Edit screen and press the EDIT button, the "Copy/
Paste" window opens as shown below.
To retain the parameters for that block, move the cursor to "Copy" and press the ENTER button.
Next, select the copy destination block with the ENTER button and then press the EDIT button. The
"Copy/Paste" window opens again.
Move the cursor to "Paste" and press the ENTER button to paste the copy source parameters.
LOOPER edit menu
On the top page in KIT mode, set SW MODE to "LOOPER", and use the VALUE knob to move the cur-
sor to the track length or level. Press the EDIT button to open the LOOPER edit menu.
The parameters you can edit using the LOOPER edit menu are shown below.
Tip: You can also access the LOOPER parameter edit screen from UTILITY.
Tip: There are three types of LOOPER Setup screens: "LOOPER", "TRACK" and "LOOPER FX". Use the METRO-
NOME knob to switch between setting pages.
Log1
Log2
Log3
59
Advertisement
Table of Contents
