Displaying And Editing The Kit Edit Menu; Selecting Insts To Assign To Pads - Korg MPS-10 Owner's Manual

Hide thumbs Also See for MPS-10:

Table of Contents

MPS-10

- Editing the KITs

Displaying and editing the KIT EDIT menu

This explains how to switch between the INSTs that are assigned to each pad.

Go to the top page in KIT mode.

If you're not in KIT mode, press the KIT button. If you're on a different page that's not in KIT

mode, press the EXIT button repeatedly until you see the top page.

Once the screen switches to the top page in KIT mode, use the KIT + and – buttons to select

the KIT you want to edit.

Once you've selected a KIT, press the EDIT button to show the KIT EDIT page.

Turn the METRONOME knob to show the PAD EDIT page.

When you press the ENTER button to select "PAD #", the pad number is highlighted.

There are 15 pads included in the KIT, which are shown in the top right corner of the screen. The

selected pad is shown with a light-blue border.

Tip: You can also strike a pad to change the pad number.

When you turn the VALUE knob to change the pad number and press the ENTER button, this

confirms the new pad number, and the screen returns to parameter selection.

At that time, all parameters aside from "PAD #" change to the pad contents that were set.

Note: If you press the EXIT button while you're changing the pad numbers, the edit is canceled and the screen

returns to parameter selection.

Table of Contents