Status Leds; Boot Display; Vcc - Led; Net St - Led - KEB COMBIVERT F6 Instructions For Use Manual

3 | Product description
3.13 Status LEDs
3.13.1 Boot display
3.13.2 VCC - LED
3.13.3 NET ST - LED
3.13.4 DEV ST - LED
16
Before the LEDs start their normal function, they signal the boot procedure after
switching on:
LEDs Status
VCC off
NET ST
DEV ST
OPT
VCC
Initialization
NET ST
DEV ST
OPT
VCC
FPGA booted
NET ST
DEV ST
OPT
VCC ready for operation Device is ready for operation and the LEDs start
NET ST
DEV ST
OPT
Tab. 3: LEDs at power on
VCC LED col- Description
our
off - Power supply of the control card switched off.
on green Control is supplied with 24 V.
Tab. 4: Function VCC LED
NET ST LED col- Description
our
off - Device off or booting.
on yellow During switching on, if FPGA is booted.
Blink various depending on fieldbus => fieldbus interfaces.
code
Tab. 5: Function NET ST - LED
DEV ST LED colour Description
OFF - Device off or in boot process.
ON Red Error
ON Yellow No error, DC bus not charged.
ON Green No error, ready for operation.
KEB Automation KG
Note
Device off
Control is supplied with 24 V
FPGA has been booted error-free (approx. 6 s)
with their normal function (approx. 3 s)
ma_dr_f6-cu-k-inst-20144795_en