Table of Contents
Advertisement
dummyhead
BF175D/BF200D/BF225D/BF250D
BATTERY (not included)
Recommended battery:
12 V – 92 Ah/5HR (CCA 800) or more capacity battery
If boat is equipped with dual outboard motors, two batteries
must be installed, one for each motor.
• Install the battery [1] in the correct size corrosion-resistant battery
box, in a dry, well-ventilated location protected from water and
direct sunlight.
• Connect the power harness (red) [2] and positive (+) battery
cable (red) [3] first, then connect the negative (–) battery cable
(black) [4]. Tighten cable nuts [5] securely.
• Coat the battery terminal ends with the non-conductive grease.
Cover the battery positive (+) terminal.
• Secure the corrosion-resistant battery box properly to the boat.
To keep potential sparks away from the fuel tank, do not secure
or place battery near the fuel tank.
BATTERY EXTENSION CABLE RECOMMENDATION
If it is necessary to extend the battery cables, do not exceed the recommended total length of the extension cables.
Battery
12 V – 92 Ah/5HR
(CCA 800)
Recommended total length of battery extension cables = Length of [1] + Length of [2] + Length of [3]
Be sure to disconnect the power harness when installing or removing the electrical part at the engine setup.
POWER HARNESS
FUSE (40 A)
[2] EXTENSION CABLE (+)
BATTERY
28
Ambient temperature
Above 0°C (32°F)
Below 0°C (32°F) ~
–15°C (–26°F)
BATTERY SWITCH
[1] EXTENSION CABLE (+)
[3] EXTENSION CABLE (–)
[5]
[4]
Recommended total length of battery extension cables
AWG4
AWG2
2
2
20 mm
30 mm
5.5 m
8.3 m
(18 ft)
(28 ft)
2.3 m
3.5 m
(8 ft)
(12 ft)
POWER EXTENSION CORD
BATTERY TERMINAL
BOARD
[3]
[2]
[1]
AWG1/0
AWG2/0
2
2
50 mm
60 mm
13.8 m
16.6 m
(48 ft)
(55 ft)
5.8 m
7.0 m
(19 ft)
(23 ft)
OUTBOARD MOTOR
STARTER CABLE
ASSEMBLY
[5]
AWG4/0
2
100 mm
26.0 m
(85 ft)
12.5 m
(41 ft)
Advertisement
Table of Contents
