Table of Contents
Advertisement
dummyhead
BF175D/BF200D/BF225D/BF250D
Mechanical model only:
[1]
Set the throttle control cable [1] and shift control cable [2] into the
grooves in the remote control cable plate [3].
[2]
[3]
Mechanical model only:
[1]
Install the remote control cable cover [1] onto the remote control
plate [2] by inserting the cover end into the plate slot.
Install the flange nuts (6 mm) [3] and tighten them.
[3]
[2]
Install the separate cover [1] over the under case grommet and onto
[2]
[3]
[4]
the engine under case [2] by aligning the groove [3] with the tab [4].
Install the flange bolts (6 x 25 mm) [5] and tighten them.
Mechanical model only: Connect the shift control cable and throttle
control cable.
• Refer to the BF175D/BF200D/BF225D/BF250D shop manual
(62ZVL00) for the tilt limit switch adjustment.
[1]
[5]
21
Advertisement
Table of Contents
