Battery Installation (For Sp Model) - TOHATSU MFS 5D LPG Owner's Manual

ENOM00029-A
2. Battery installation (For SP
model)
ENOW00012-1
WARNING
Battery electrolyte contains sulfuric acid
and is hazardous, causes a burn if come in
contact with your skin, and poisonous if
swallowed.
Keep batter y and electroly te away from
reach of children.
When handling the battery, be sure to:
 Read all warnings shown on the battery
case.
 Prevent electrolyte from coming in con-
tact with any part of your body. Contact
can cause serious burn or, if come in con-
tact with your eye, loss of sight. Use
safety glasses and rubber gloves.
In case you came in contact with battery
electrolyte:
 For skin, flush thoroughly with water.
 For eye, flush thoroughly with water, and
then seek immediate medical treatment.
In case battery electrolyte is swallowed:
 Seek immediate medical treatment.
ENOW00013-B
WARNING
Battery generates explosive hydrogen gas.
Be sure to:
 Charge the battery in a well-ventilated
place.
 Place the battery away from any source of
fire, sparks and open flames such as
burners or welding equipment.
 Do not charge the battery when the elec-
trolyte level is low. Otherwise, the bat-
ter y will be damage d and may cause
malfunction.
ENOW00014-0
CAUTION
 Make sure that the battery leads do not
get stuck between the outboard motor
and boat when turning, etc.
 The starter motor may fail to operate if
the leads are incorrectly connected.
 Be sure to correctly connect the (+) and
(—) leads. If not, the charging system will
be damaged.
 Do not disconnect the battery leads from
battery while the engine is operating, the
electrical parts could be damaged.
 Always use a fully charged battery.
ENOW00015-1
CAUTION
Do not use a batter y that is not recom-
mended. Use of a battery not recommended
can lead to poor performance of, and/or
damage to the electrical system.
ENON00006-1C
Note
Minimum batter y requirements: 12V
40Ah/20HR, 330 Cold Cranking Amps
(CCA).
Larger capacity battery is required when it
is used under a freezing condition.
Recommend connecting only the engine
battery cables to the starting battery.
Specifications and features of battery vary
by manufacturers.
Consult the manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the out-
board motor.
1. Connect the battery cable to the
leads that come from the bottom
cowl.
21
INSTALLATION
5