Table of Contents
Advertisement
dummyhead
BF175D/BF200D/BF225D/BF250D
10.After connecting the cable, move the remote control lever back
and forth and check for proper shifting.
If it is hard to put the remote control lever in the "F" (Forward) or
"R" (Reverse) position with the engine stopped, shift the gear
while turning the propeller or propeller shaft. Do not shift the gear
with force, or damage to the shift system can result.
11.If the gear is not in neutral by moving the remote control lever
from the "F" (Forward) to the "N" (Neutral) position, remove the
shift side cable and move the inner cable toward the mark (A) [1].
Repeat the procedure from the step 8.
12.If the gear is not in neutral by moving the remote control lever
from the "R" (Reverse) to the "N" (Neutral) position, remove the
shift side cable and move the inner cable toward the mark (B) [1].
Repeat the procedure from the step 8.
13.After adjustment, check operation of each lever. If the gear is not
in neutral properly, perform steps 12 or 13 again.
THROTTLE CONTROL CABLE CONNECTION
(Mechanical model only)
• Before installing the cable to the outboard motor, check that the
cable is connected to the remote control box side properly.
1. Apply marine grease to the link pin of the throttle arm [1].
Install the throttle pivot (White) [2] to the link pin.
Lock the cable pivot by sliding lock plate [3] into the groove in the
link pin.
24
ADJUSTMENT
RANGE
[1]
ADJUSTMENT
RANGE
[1]
[2]
[3]
[1]
Advertisement
Table of Contents
