Table of Contents
Advertisement
dummyhead
BF175D/BF200D/BF225D/BF250D
Propeller Installation
• Disconnect the battery cable terminal to prevent the engine from starting accidentally.
The propeller blades may have sharp edges
or burrs.
You can be cut or injured if you come in
contact with sharp metal.
Always wear heavy gloves when handling
propellers to protect your hands from any
sharp edges.
Apply marine grease to the propeller shaft.
Install the thrust washer [1] and the propeller (Not included) [2] on
the propeller shaft.
Install the propeller washer [1] and castle nut (18 mm) [2].
Tighten the castle nut (18 mm) and secure with the split pin [3].
TORQUE: 1 N•m (0.1 kgf•m, 0.7 lbf•ft)
If the split pin does not align with the hole in the propeller shaft,
adjust by turning the nut in the tightening direction. Do not exceed
the maximum torque.
Maximum tightening torque:
44.1 N•m (4.5 kgf•m, 32 lbf•ft)
After installation, bend the split pin [1] ends around the nut as
shown.
If the commercially available parts are used, only use stainless steel
parts.
32
[1]
[3]
[1]
[2]
[1]
[2]
Advertisement
Table of Contents
