If Your Modem Doesn't Respon D3-3; Remote Flash - 3Com Courier Reference

If Your Mode
Doesn't Respond

Remote Flash

If your modem doesn't respond after the flash process, its memory may
be corrupted. Follow these steps to force the new software to the
modem.
1 Power your modem on.
2 Start your communications software package. Set your port speed to
57,600 bps, type
AT
If the Courier V.Everything modem reports .bootmodem., it is corrupt.
Issue the
ATXMODEM
previous page.
3 Power your modem off
4 Set the DIP switches to their previous settings.
5 Power your modem on.
In order to upgrade the modem located at a remote site, you need to
ensure that the remote modem is enabled for remote access (see Chapter
9). Call the remote modem from your local site and follow the steps
outlined in that chapter.
If Your Modem Doesn't Respond
and press Enter.
command and repeat the flash process found on the
3-3