Setting Up Ra; Determining If Tcp/Ip Is Installe D1-1 - 3Com Courier Reference

1-10 C 1: C
HAPTER ONNECTING TO YOUR

Setting up RA

Determining if TCP/IP
is installed
ISP
Your modem should already be installed. If you have not connected your
Courier V.Everything modem to your computer, please refer to the
Getting Started Manual for installation instructions.
1 Go to Start | Settings | Control Pane | Modems.
2 Click Add.
3 Check Don't detect my modem; I will select it from a list.
4 Click Next.
5 Click Have Disk.
6 Place the 3.5-inch diskette or CD-ROM that was packaged with your
Courier V.Everything modem into your 3.5-inch diskette or CD-ROM
drive. Select the INF file found on the disk.
7 Select the COM port for your Courier V.Everything modem.
8 When the installation is complete, Windows NT will request that yo
restart your computer. Select Yes.
1 Right click the Network Neighborhood icon on your desktop and select
Properties.
2 Click the Services tab.
3 Select Remote Access Service and click Properties.
4 Click Add.
5 Select your Courier V.Everything modem's COM port and click OK.
6 Highlight your Courier V.Everything modem and click Configure.
7 Select the function of your modem and click OK.
8 Click Network
9 Select the protocols required to dial in and out with your Courier
V.Everything modem.
10 Set Encryption Settings to Allow any authentication including clear
text.
11 Click Continue to complete RAS setup
TCP/IP must be installed before you can access the Internet. Although this
is a standard configuration, double-check to make sure TCP/IP is installed.