Table of Contents
Advertisement
Autopass Prompting
Password Prompting
Autopass is the default form of password protection. Autopass
automates the process of logging in to the host modem, but it requires
the guest and host devices to be Couri e r V.Everything modems.
When a guest device attempts an Autopass connection, the guest
includes its password in its V.42 error-control request. The host mode
checks all the enabled passwords in its security accounts for a match.
Password Prompting allows connections with any guest device, as long as
the guest user knows the correct password.
When the host has Password Prompting enabled, it asks guest users for a
password. The host modem checks the received password against each of
its active Security accounts
There is no Password Prompting capability in synchronous mode.
The table below is a comparison between Autopass and Password
prompting.
When using Autopass Prompting
Both the host and guest devices are made
by 3Com and have Dial Security enabled.
The connection between the Courier
V.Everything modem or modems is under
V.42 error control (See Appendix B,
Alphabetic Command Summary for
information about using AT&M4 or
AT&M5)
If the guest includes an invalid password,
the host sends an INVALID PASSWORD
message and hangs up.
If the guest includes a valid password, the
host permits a secure connection.
If the guest did not enable Dial Security,
the host will not accept the call unless
prompting is enabled on the host Courier
V.Everything mode .
Setting up Dial Security
When using Password Prompting
Guest devices don't have to support
3Com Dial Security.
V.42 error-control connections aren't
required
If the guest sends an invalid password,
the host prompts twice more before
disconnecting.
If the guest does not send a password
after 60 seconds, the host disconnects.
The host will still always respond to a
correct Autopass attempt.
11-5
Advertisement
Table of Contents
