Installing Tcp/I P1-11; Configuring A Ppp Connectio N1-1 - 3Com Courier Reference

1 Select Start | Settings | Control Panel.
2 Double-click Network.
3 On the Protocol tab, scan down the list of installed protocols to find
4 If TCP/IP Protocol is listed, skip to section Configuring a PPP Connection.
Installing TCP/I
1 Select Start | Settings | Control Panel.
2 Double-click Network.
3 On the Protocol tab, click Add, and select the TCP/IP protocol from the
Configuring a PP
connection
1 Go to Start | Programs | Accessories | Dial Up Networking.
2 Click New.
3 Select the Server tab and select PPP in the Dial-up server type box.
4 Select TCP/IP.
5 Deselect NetBEUI and IPX.
6 If you are connecting to an I S P, uncheck Enable PPP LCP Extensions.
7 Select Enable software compression.
8 Specify an IP address by clicking TCP/IP settings.
To determine if TCP/IP is installed, perform the following actions:
TCP/IP Protocol Adapter.
If TCP/IP Protocol is NOT listed, move to the next section
To install TCP/IP, perform the following actions:
list.
To configure the Courier V.Everything modem for a PPP connection,
perform the following actions:
If you are connecting to another Windows NT system, Check Enable PPP
LCP Extensions.
If your ISP
Gives you a specific IP address
Does not give you a specific IP address
Windows NT 4.0
Do this
Click Specify an IP address and enter
the IP address provided by your ISP
Click Server assigned IP address
1-11