Table of Contents
Advertisement
Maintaining
Security Accounts
Remote
Configuration
Once the administrative password is set and Dial Security is enabled, the
administrator is the only one who can access account information.
You can use the AT%S= and AT%E= commands to change and modify
account information.
For your modem to
Access accounts by disabling local security
View account information, once access has been
granted.
Remote users may only use this command during
remote-access sessions if local-access security is
disabled.
Erase local-access password
Erase Autopass password
Erase passwords in accounts 0-9
Erase phone numbers in accounts 0-9
Disable Account, Dialback, and New Number
fields in accounts 0-9.
Edit or overwrite an individual account or an
individual account field
Example: Sending
AT%E=3
When using the AT%S= command, the device echoes the administrative
password, which is case-sensitive. Courier V.Everything modems will
accept an invalid password entry, but will lock out users from the security
commands.
For example, if the password is Green, but you enter GREEN, an OK is
displayed. However, if you try to type a security command (for example,
ATI10 to view accounts), an [ACCESS DENIED] message is displayed.
Dial Security accounts may be configured remotely. (See Configuring Dial
Security Remotely at the end of this chapter.)
Maintaining Security Accounts
Command
AT%S=administrative password
ATI10
AT%E=1
AT%E=2
AT%E=3
AT%E=4
AT%E=5
AT%An=
where n is the account
number.
See the figure in previous
section, Setting Up Dial
Security for more information.
erases passwords for accounts 0-9
11-7
Advertisement
Table of Contents
