Table of Contents
Advertisement
Ampersand (&)
Command Set
See Appendix A S-Registers for a listing of all the S-Registers.
Command
Function
Vn
Display result codes in words or numbers.
V0
V1
Xn
Control the amount of information displayed in the result
codes. The default is X7 (all codes except 12/VOICE).
For result codes in synchronous operations, see Chapter 16,
Analogue Synchronous Applications. For more detailed
information, see Appendix D, Result Code Meanings and Sets.
X3
X4
X7
Z
Software reset. If DIP Switch 1 is ON (factory setting), revert to
the settings in NVRAM. If DIP switch 1 is OFF, reset to the &F0
configuration template (no flow control).
Z!
Complete hardware reset
Command
Function
&$
Display help for the ampersand (&) command set.
&An
Enable or disable the display of additional result code subsets.
(Also, see the Xn command.)
&A0
&A1
&A2
&A3
&Bn
Set the serial port rate to variable or fixed.
&B0
&B1
Ampersand (&) Command Set
Display result codes in numeric form.
Display result codes in verbal form.
Ignore Dial Tone
Microsoft default
Courier V.Everything modem default
Do not display ARQ result codes.
Display ARQ result codes.
In addition to ARQ result codes, display HST, V.32,
V.FC, V.34, or DIGITAL modulation indicator.
In addition to ARQ and modulation indicators,
display an error control indicator (LAPM, HST, MNP,
SYNC, V.120, or NONE) and a data compression
type (V42 bis or MNP5).
Variable: The serial port rate adapts to match the
speed of the connection.
Fixed: The modem always communicates with your
computer at the rate at which you have set,
regardless of the connection rate.
B-5
Advertisement
Table of Contents
