Table of Contents
Advertisement
16-2
C
16: D
HAPTER
EDICATED
Requirements
A Device with a
Synchronous Serial
Port
A Serial Cable
Communications
Softwar
Synchronous
Operations
/L
L
EASED
INE AND SYNCHRONOUS APPLICATIONS
The information below describes device requirements.
Find out what hardware and software you need before proceeding.
You will probably have to purchase and install a synchronous adapter
card. These cards provide:
A synchronous serial port
Support for one or more synchronous protocols.
Additional software functions. For example, the card may tell the
mainframe what type of computer or terminal you are using. The card
may also tell the mainframe what resources you want to use.
Obtain a shielded serial cable with a male DB-25 connector on one end
and a connector on the other end that is appropriate for your
synchronous serial port. Your modem provides an EIA-232 interface
through its serial port.
Transmit and Receive synchronous timing pins are required at the EIA-232
interface, so pins 15 and 17 are required. The modem transmits timing
signals through pin 15 and receives timing signals through pin 17
Note: The serial cable included with your modem only supports
asynchronous mode.
The devices at both ends of the link must use the same synchronous
protocol.
Ask your network administrator about the software support (for example
a specific communications package) that you need to log into the
network.
During synchronous operations, transmit and receive clocks at both ends
of the phone link control the precise timing of the data flow. The
communications equipment at the remote device, your modem and
computer must all handle the data at the same speed.
Your modem is usually the source of the transmit clock timing signals and
sends them to your computer over the EIA-232 interface. Your
computer's rate will follow the connection rates.
Advertisement
Table of Contents
