Table of Contents
Advertisement
Other Remote-Access
Commands
Accessing the Host
At the Guest Device
The table below is a list of remote-access configuration commands.
For your modem to
Display a view-only password
Display a view-and-change password
Erase a view-only password
Erase a view-and-change password
Disable remote access entirely
Example: Sending
WARNING: If you erase the%P1 password without disabling remote
access (using
ATS41=0
modem and change its configuration.
The guest device requires no configuration to access the host. Follow
these steps:
1 Be sure that the host device has enabled remote access and is set to
auto-answer (
ATS0=1
2 Call the host device (although it doesn't matter which device originates
the call).
3 After a connection is established, do this:
a Pause 4 seconds.
b Type 4 tildes: ~~~~
c Pause 4 seconds.
The administrator of the host device can change the remote-access
character using S-Register 42, and the pause duration using S-Register
43. See Appendix A, S-Registers for more information.
will erase the view and change password
AT%P1=
), anyone could access the Courier V.Everything
). Know the password, if you will need one.
Accessing the Host
Command
AT%P0?
AT%P1?
AT%P0=
AT%P1=
ATS41=0
9-3
Advertisement
Table of Contents
