Using Decimal Value - 3Com Courier Reference

Using Bits
Using Decimal
Values
Default S-Register
Settings
Turning individual bits on and off is the more direct way to set
bit-mapped S-Registers. To do this, specify the S-Register that you want
to set and then indicate which bits you want to turn on (1) or off (0).
Example:
ATS13.0=1.4=1.5=1
An alternative way to set bit-mapped S-Registers is by adding the decimal
values of the bits and entering the total.
This example,
ATS13=49
above:
The table below lists all default values for S-Register settings.
S-Registers
S0
S1
S2
S3
S4
S5
S7
S8
S9
S10
S11
S12
S13
S14
S15
S16
S18
S19
, turns bits 0, 4, and 5 on for S-Register 13.
, sets the same value as the one in Using Bits
Function
Auto Answer
Counts & stores rings from incoming
calls
Escape code character
Carriage Return character
Line Feed character
Backspace character
Carrier wait-time, sec
Dial pause, sec
Carrier Detect time, 100 ms
Carrier loss wait-time, 100 ms
Tone duration, spacing, ms
Escape code guard time, 500 ms
Bit-mapped functions*
Bit-mapped functions*
Bit-mapped functions*
Test modes
&T test timeout
Inactivity/hang up timer
Using Bits A-3
NVRAM Default
Setting
0
0
43
13
10
8
60
2
6
7
70
50
0
0
0
0
0
0