Configuring Dial Security Remote; Dialing In From The Remote S - 3Com Courier Reference

Configuring Dial
Security Remotely
3 If Dialback is enabled at the host Courier V.Everything modem's site, set
your modem to answer the host Courier V.Everything modem when it
dials back.
For your modem to be set
To answer the Dialback call
4 Call the host.
5 After the call ends you can disable Auto Answer.
For your modem to
Disable Auto Answer
The host administrator can configure the host's security settings remotely.
At the host device, you must have previously enabled remote access and
assigned a remote-access password that allows view-and-change
privileges (see Chapter 9, Accessing and Configuring the Courier
V.Everything modem remotely). You may want to use your administrative
password as your remote-access password.
Dialing In From the Remote Site
1 From the remote site, connect to the host using Dial Security. Once a
connection is made, follow the instructions for beginning a
remote-access session as described in Chapter 9, Accessing an
Configuring the Courier V.Everything modem remotel .
2 When remote access has been granted, use the AT%S= command t
access the Dial Security accounts. See Maintaining Security Accounts
section earlier in this chapter.
To view the security account information use
3 Make any configuration changes and execute them immediately by
entering .
AT%C2
4 To end the remote session and reactivate Dial Security on the host, reset
the host device by issuing
Configuring Dial Security Remotely
Command
ATS0=1
Command
ATS0=0
ATI10
.
ATZ
11-9
.