1.
Draw the pre-prepared LAN connector through the stand bottom and connect it into the
LAN connector socket. Place the cable into the pre-prepared groove in the center of the
stand bottom. Unstick the protective foil from the stand antislip surfaces.
Caution
We recommend that you use a CAT5e UTP cable to fit the stand bottom groove
size.
2.
Put the stand including the properly drawn and connected cable on the device. First snap
in the stand hooks, then tilt the stand towards the device and lock the latch on the stand
top edge into the device body.
Now the device is ready for basic operation. It is necessary to perform
achieve full functionality of the device.
To remove the device from the stand, reverse the steps - start by releasing the locking latch on
the top edge of the stand.
3.4 Device Removal
2N® Clip User Manual
software configuration
17 / 75
to