Device Restart; Factory Reset - 2N IP Solo Installation Manual

Device Restart

Factory Reset

®
2N Helios IP Solo is equipped with a RESET button. Press the button shortly (< 1 s) to
restart the system without changing configuration.
Follow the instructions below to
Press and hold the RESET button.
Wait until the red and green LEDs on the device come on simultaneously
(approx. 20 s).
Release the RESET button.
The device announces the current IP address via the loudspeaker connected
automatically.
Follow the instructions below to switch on the
Press and hold the REST button.
Wait until the red and green LEDs on the device come on simultaneously
(approx. 20 s).
Wait until the red LED goes off (approx. 5 s).
Release the RESET button.
The following network parameters will be set after restart:
IP address: 192.168.1.100
Nework mask: 255.255.255.0
Default gateway: 192.168.1.1
Follow the instructions below to switch on the
2N TELEKOMUNIKACE a.s., www.2n.cz
identify the current IP address
Static IP address
Dynamic IP address
:
mode (DHCP OFF):
mode (DCHP ON):
40/66