Device Configuration - 2N Helios IP Vario Installation Manual

3.1 Device Configuration

Use a PC equipped with any web browser to configure 2N



You have to know the IP address of your device to log in to the integrated web server.
By default, 2N
obtains the IP address automatically if a properly set DHCP server is available in your
LAN. If no such DHCP server is available, you can operate 2N
static IP address mode. Refer to the 2N
configuration details.
If your device remains inaccessible (you have forgotten the IP address, or the LAN
configuration has changed, for example), change the LAN settings using the buttons
on the device.
Static IP Address Setting
Follow the instructions below to enable the static IP address mode:





Figure 3.1
Launch your web browser (Internet Explorer, Firefox, etc.).
Enter the IP address of your intercom (http://192.168.1.100/, e.g.).
Log in using the Admin user name and 2n password.
®
Helios IP Vario is switched into the dynamic IP address mode, i.e. it
®
Connect 2N Helios IP Vario to the power supply (or, disconnect and
reconnect it if already connected).
Wait for the first acoustic signal
Press following buttons sequentially:
1, 1, 1, 2, 2, 3 for 3-buttons models
o
4, 4, 4, 5, 5, 6 for 6-buttons modely
o
The acoustic signal
Wait until the device is restarted automatically.
Switching to static IP address
Device Configuration
®
Helios IP Configuration Manual for
.
indicates mode switching.
®
Helios IP Vario:
®
Helios IP Vario in the
3.1
40