Device Configuration; Maintenance & Cleaning - 2N Clip Brief Manual

Device Configuration

Configuration is made via the device web interface. Connect the device to the LAN IP and make sure it is properly powered. You have
to know the IP address for access. To retrieve the device address:
• enable the IP address display on the device in Settings > About device (press the handset and speaker buttons simultaneously
to get to Settings),
• via the 2N Network Scanner; refer to 2N.com for download,
using the RESET button as shown in Figure 6:
•
1. Press and hold the RESET button.
2. Wait until the red and green LEDs on the device come on simultaneously and sound signaling is heard
(approx. 15–35 s).
3. Release the RESET button.
4. The device announces the current IP address via the speaker automatically (in English).
Enter the found IP address into the web browser. Accept the safety warnings of some browsers as your acceptance is not in
contradiction to a safe use of your device. The factory login data are: username: admin and password: 2n.
Once logged in, you can start configuring your device via the web interface. Refer to the User Manual at wiki.2n.com for configuration
details. Find the direct link on the configuration interface introductory page.
Control
Three buttons on the device front side are used for main control – handset, lock and speaker buttons. Use a short press, long press and
simultaneous long press of multiple buttons to control the buttons. See the table below for control options:
Button
Handset
Lock
Speaker
Lock + Speaker
Handset + Speaker
Technical Parameters of Device
• Power Supply: PoE 802.3af (Class 0, max. 12,95 W),
• Display: 4" with 480 x 272 pixel resolution,
• Microphone and speaker: integrated,
• Weight: 295 g.
Type of press
Short press
Long press
Short press
Long press
Short press
Long press
Simultaneous long press of both
buttons
Simultaneous long press of both
buttons
Generated action
Call on device A
Call on device B
Unlocks lock A
Unlocks lock B
Increases volume by one level (after the upper limit is
reached, it goes to the lowest value – value rotation)
Menu is displayed with the ringtone list
Turn on / off the device lock
Device Setting Display
Maintenance - Cleaning
• If used frequently, the device surface gets dirty. Use a piece of soft
cloth moistened with clean water to clean the device.
It is recommended that the principles below are followed while
cleaning
• Do not use aggressive detergents (such as abrasives or strong
disinfectants). Use appropriate cleaning agents suitable for glasses,
optical devices, screens, etc. Alcohol-based cleaners may not be
applied. We recommend that IT cleaning wipes are used.
17
2