Table of Contents
Advertisement
2N® Clip User Manual
Test Call – display a dialog box enabling you to make a test call to a selected phone
number, see below.
Authentication
Use Authentication ID – select the use of an alternative ID for device authentication.
Otherwise, the Phone number value defined above is used.
ID for authentication – select the use of an alternative user ID for device authentication.
Password – set the password for device authentication. If your PBX requires no
authentication, the parameter will not be applied.
SIP Proxy
Proxy Address – set the SIP Proxy IP address or domain name.
Proxy Port – set the SIP Proxy port (typically 5060).
Backup Proxy Address – SIP Proxy IP address or domain name. The address will be used
where the main Proxy fails to respond to requests.
Backup Proxy port – set the backup SIP Proxy port (typically 5060).
SIP Registrar
Allow Registration – allow the device to be registered with the set SIP Registrar.
Registrar Address – set the SIP Registrar IP address or domain name.
Registrar Port – set the SIP Registrar port (typically 5060).
Backup Registrar Address – set the backup SIP Registrar IP address or domain name. The
address is used where the main Registrar fails to respond to requests.
Backup Registrar Port – set the backup SIP Registrar port (typically 5060).
Registration Expiry – set the registration expiry, which affects the network and SIP
Registrar loads by periodically sent registration requirements. The SIP Registrar can modify
the expiry limit without letting you know.
Registration Status – display the current registration status (Unregistered, Registering...,
Registered, Registration completing...).
Cause of Failure – display the cause of the last registration attempt failure – the Registrar's
last error response, e.g. 404 Not Found.
Advanced Settings
SIP Transport Protocol – set the SIP communication protocol: Choose UDP (default), TCP
or TLS.
Lowest Allowed TLS Version – set the lowest TLS version to be accepted for server
registration and connection setup.
Verify Server Certificate – verify the SIP server public certificate against the CA certificates
uploaded in the device.
Client Certificate – specify the client certificate and private key used for verifying the
intercom's authority to communicate with the SIP server.
Local Port for SIP – set the local port to be used for SIP signaling. A change of this
parameter will not be applied until the device is restarted. The default value is 5060.
36 / 75
Advertisement
Table of Contents
