Hoisting A Cabinet - Huawei PowerCube 1000 Installation Manual

PowerCube 1000 (STC, Saudi Arabia, ICC800-A1-C2,
ESC800-A1)
Installation Guide
Figure 7-4 Replacing the flat washer
Step 3 Drill a hole into the concrete floor using a hammer drill. The hole depth should
range from 50 mm to 55 mm.
Step 4 Partially tighten an expansion bolt, place it vertically into the hole, and use a
rubber mallet to pound it until the expansion sleeve completely enters the hole.
Step 5 Partially tighten the expansion bolts.
Step 6 Remove the bolt, flat washer, and spring washer.
Figure 7-5 Drilling holes and installing expansion sleeves
(1) M12 bolt
(4) Expansion sleeve
----End

7.3 Hoisting a Cabinet

Procedure
Step 1 Remove the sealing nuts from the top of the cabinet.
Issue 02 (2021-09-28)
NO TE
Keep the removed sealing nuts properly. Reinstall them after hoisting the cabinet.
Copyright © Huawei Technologies Co., Ltd.
(2) Spring washer
(5) Expansion nut
7 Installing the Cabinet
(3) Flat washer
(6) Concrete floor
74